Humidity Sensor in Fresh Air Intake Duct -G657- /Air Quality Sensor -G238-, REMOVING AND INSTALLING: Removing
WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2022 Audi SQ5, 2022 Audi Q5 e, 2022 Audi Q5, 2021 Audi SQ5, and 2021 Audi Q5 e. However, it is still accessible from the selected car via links, so may be relevant.
-- Switch off the ignition.
-- Loosen the right front plenum chamber cover -F- from the vehicle and carefully lift slightly. Refer to PLENUM CHAMBER COVER, REMOVING AND INSTALLING .
-- Rotate the Air Quality Sensor -G238- /Humidity Sensor in Fresh Air Intake Duct -G657- -A- approximately 90° and remove it from the mount on the fresh air intake -E-.
-- Disconnect the connector -B- from sensor -A-.
TIP
- Disconnecting the connector -1- takes place by pulling the connector housing -1- in the direction of the arrow -A-.
- If this is not possible, the connector can be disconnected by pressing the hook -2- in the direction of the arrow -B- and pulling the connector housing -1- in the direction of the arrow -A-.