Relay and Fuse Panel 4 -SR4-, REMOVING AND INSTALLING: Removing
WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2022 Audi SQ5, 2022 Audi Q5 e, 2022 Audi Q5, 2021 Audi SQ5, and 2021 Audi Q5 e. However, it is still accessible from the selected car via links, so may be relevant.
-- Remove the right front sill panel. Refer to SILL PANEL, REMOVING AND INSTALLING .
-- Disconnect the ground cable from the battery when the ignition is switched off. Refer to BATTERY, DISCONNECTING AND CONNECTING, 0K0 AND VH0 .
-- Push the carpet in the area of the footwell to the side as far as possible.
-- Release the catch -5- and open the cover -4- in direction of -arrow-.
-- Remove the nuts -1, 2 and 3- and free up the wires.
-- Remove the relay -2- from the mount -1- by opening the clip in direction of -arrow-.
-- Release the retainer in direction of -arrow- and remove the wire junction -1-.
-- Release the clips in direction of -arrows- and press the relay panel -2- back and out of the bracket -1-.