Relay and Fuse Panel 1 -SR1-, REMOVING AND INSTALLING: Removing

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2022 Audi SQ5, 2022 Audi Q5 e, 2022 Audi Q5, 2021 Audi SQ5, and 2021 Audi Q5 e. However, it is still accessible from the selected car via links, so may be relevant.

-- Remove the lower cover on the driver side. Refer to DRIVER SIDE INSTRUMENT PANEL COVER, REMOVING AND INSTALLING .

-- Remove the left front sill panel. Refer to SILL PANEL, REMOVING AND INSTALLING .

-- Remove the left front seat. Refer to FRONT SEAT, REMOVING AND INSTALLING .

-- Disconnect the ground cable from the battery when the ignition is switched off. Refer to BATTERY, DISCONNECTING AND CONNECTING, 0K0 AND VH0 .

-- Push the carpet in the relay and fuse panel one area to the side as far as possible.

-- Disconnect the connectors -1 and 2-.

Courtesy of AUDI OF AMERICA, LLC

-- Cut the cable tie.

-- Remove the nuts -arrows-.

-- Remove the relay and fuse panel one -3- from the threaded pins and remove it from the body toward the inside.

TIP:

The carpet must be removed if the relay and fuse panel one cannot be removed as described. Refer to CARPET, REMOVING AND INSTALLING .

-- Release the clip in direction of -arrow-, push the fuse panel -2- out toward the rear and disengage it from relay and fuse panel one -1-.

Fig 1: Fuse Panel

Courtesy of AUDI OF AMERICA, LLC

-- Open the clip and remove the auxiliary fuse panel -2-.

Fig 2: Auxiliary Fuse Panel

Courtesy of AUDI OF AMERICA, LLC

-- Release the clips in direction of -arrows- and remove the relay -1- and the control modules from the relay panels.

-- Open the clips in direction of -arrows- and press the relay panel -3- toward the rear and out of the bracket -4-.

Fig 3: Identifying Relay Carrier

Courtesy of AUDI OF AMERICA, LLC

-- Open the clip -1- and remove the connector terminal -2- from the bracket.

-- Remove relay and fuse panel one.