Installed Overview

Fig 1: Identifying Overview Of Assembled Calibration Equipment

Courtesy of AUDI OF AMERICA, LLC

1. :VAS6350/1 
2. :VAS6350/1 
3. Right Angle Bracket
   • :VAS6350/2  mount
4. Plastic Foot
   • Three on underside of the calibration board
   • Adjustable for aligning horizontal position of the calibration board
5. :VAS6350/3 
   • On the calibration board
   • Switching on and off. Refer to the Owner's Literature.
6. :VAS6350/2 
   • On the calibration board
   • Refer to the Owner's Literature for notes on the operation.
7. Level
   • On the calibration board
   • For checking the horizontal position
8. Left Angle Bracket
   • :VAS6350/2  mount
9. Calibration Board
   • Between the mounts on the calibration board and the :VAS6350/1  -dimension A- 1.47 m through 1.90 m

Calibration Board Orientation

-- Position the calibration platform behind the vehicle at a distance of 1.47 m to 1.90 m to the rear wheels, see -dimension A- in the overview illustration. Refer to Installed Overview .

-- Bring the :VAS6350A  into a horizontal position.

-- Twist the plastic feet under the calibration board so that the air bubble in the level is located exactly in the center of the indicator -arrow-.

Fig 2: Identifying Bubble Level (Sight Glass) On Calibration Tool VAS 6350

Courtesy of AUDI OF AMERICA, LLC

NOTE:

The vehicle in the illustration is only a basic outline.

Fig 3: Identifying Laser -1- On Calibration Platform Set To Align Entire Calibration Platform With Vehicle

Courtesy of AUDI OF AMERICA, LLC

-- Switch on the :VAS6350/3  -1- on the calibration board and adjust the entire :VAS6350A  so that the laser beam hits the center of vehicle rear above the Audi rings.

-- Check that the Audi rings are centered on the rear. Correct the laser beam accordingly.

Continue calibrating the Rearview Camera -R189-. Refer to Rearview Camera -R189-, CALIBRATING .