Overview - Infotainment System, MMI Radio Plus, 18E
On the "MMI Radio plus" Infotainment system, the following functions are integrated in the Information Electronics Control Module 1 -J794- :
MMI Radio plus Infotainment System Properties
- Information Electronics Control Module 1 -J794- with integrated CD player/SD card reader in the glove compartment
- Multimedia System Control Head -E380- in the center console, UJ0
- Front Information Display Control Head -J685-, 7 inch display, in the center of the instrument panel
- External Audio Source Connection -R199- in the center console storage compartment, USB charging, AUX IN, UE4
- Sound system: basic sound, 8RM
- Video input for rearview camera system, KA2
- Bluetooth interface, 9ZX
- Multifunction Steering Wheel
Optional
- Digital Radio -R147- integrated in the Information Electronics Control Module 1 -J794-, only Europe/Rest of World and QV3
- Radio System, Satellite -R146- integrated in the Information Electronics Control Module 1 -J794-, only USA and QV3
- Digital Sound System Control Module -J525- in the left rear side of the luggage compartment, 9VS
- Instrument Cluster Control Module -J285-, color display in the instrument cluster, 9S7
- External Audio Source Connection -R199- in center console storage compartment, USB (quantity: 2), AUX IN, UE7
- Sound System: Audi Sound System, 9VD
- Bang & Olufsen Sound System, 9VS
- Audi phone box, 9ZE
- Front Information Display Control Head -J685-, Display in Center of the Instrument Panel
- Rear Window Antennas
- Information Electronics Control Module 1 -J794- in the Glove Compartment
- Multimedia System Control Head -E380- in the Center Console
- Driver Volume Control -E67- in the Center Console
- MOST Bus
- Digital Sound System Control Module -J525- in Luggage Compartment on Left Rear Side
- External Audio Source Connection -R199- in the rear center console storage compartment
- Sound Systems
The MOST bus performs the system data exchange in the CAN bus and MMI.
Fault Finding is performed using the "Guided Fault Finding". Refer to Vehicle Diagnostic Tester.
Notes on MOST bus
The optical data bus "MOST bus" is used in addition to the CAN bus.
A fiber-optic cable is used. Fiber optic cables are routed inside corrugated tubes for protection.
Replace the complete fiber-optic cable if possible.
The front surface of the connectors must not be contaminated.
If disconnecting the connectors: Attach the :VAS6223/9 .
When routing fiber-optic cables, make sure not to go below the minimum bending radius of 25 mm. Do not crush or kink fiber optic cables.
Repairing fiber-optic cables. Refer to GENERAL REPAIR INFORMATION .