LEMON Manuals: Even more car manuals for everyone
Home >> Audi >> 2020 >> Q5 Premium Plus >> Repair and Diagnosis >> External Pages >> Different car >> Section 13 (Communication) >> 91 Communication >> Infotainment System >> Overview - Infotainment System >> Overview - Infotainment System, MMI Navigation Plus, I8H+7UG

Overview - Infotainment System, MMI Navigation Plus, I8H+7UG

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2022 Audi SQ5, 2022 Audi Q5 e, 2022 Audi Q5, 2021 Audi SQ5, and 2021 Audi Q5 e. However, it is still accessible from the selected car via links, so may be relevant.

On the "MMI Navigation plus" Infotainment system, the following functions are integrated in the Information Electronics Control Module 1 -J794- :

Infotainment System Characteristics - MMI Navigation Plus

Optional

ASI - Audi Smartphone Interface

GWWA91-12799Courtesy of AUDI OF AMERICA, LLC
  1. Front Information Display Control Head -J685-, Display in Center of the Instrument Panel
  2. GPS Antenna -R50- in the Roof Antenna -R216-
  3. Rear Window Antennas
  4. Bumper Antennas
  5. Information Electronics Control Module 1 -J794- in the Glove Compartment
  6. Multimedia System Control Head -E380- in the Center Console
  7. Driver Volume Control -E67- in the Center Console
  8. Instrument Cluster -KX2-, "Audi virtual cockpit"
  9. MOST Bus
  10. Digital Sound System Control Module -J525- in Luggage Compartment on Left Rear Side
  11. TV Tuner -R78- in Luggage Compartment on Rear Right Side
  12. External Audio Source Connection -R199- in the rear center console storage compartment
  13. Sound Systems

The MOST bus performs the system data exchange in the CAN bus and MMI.

Fault Finding is performed using the "Guided Fault Finding". Refer to Vehicle Diagnostic Tester.

Notes on MOST bus

The optical data bus "MOST bus" is used in addition to the CAN bus.

A fiber-optic cable is used. Fiber optic cables are routed inside corrugated tubes for protection.

Replace the complete fiber-optic cable if possible.

The front surface of the connectors must not be contaminated.

If disconnecting the connectors: Attach the :VAS6223/9  .

Fig 1: Fiber-Optic Conductor Repair Set VAS 6223A
GWWW00-11495Courtesy of AUDI OF AMERICA, LLC

When routing fiber-optic cables, make sure not to go below the minimum bending radius of 25 mm. Do not crush or kink fiber optic cables.

Repairing fiber-optic cables. Refer to GENERAL REPAIR INFORMATION .