Information Electronics Control Module 1 -J794-, REMOVING AND INSTALLING: Removing

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2022 Audi SQ5, 2022 Audi Q5 e, 2022 Audi Q5, 2021 Audi SQ5, and 2021 Audi Q5 e. However, it is still accessible from the selected car via links, so may be relevant.

-- Open the glove compartment.

-- Remove any CD/DVDs and SD/SIM cards from the Information Electronics Control Module 1 -J794-.

-- Turn off the ignition and all electrical equipment and remove the ignition key.

-- Insert the two clips from the :T10057 into the slits in the Information Electronics Control Module 1 -J794- -1- until they lock into place. The points on the gripping eyelets face outward.

Courtesy of AUDI OF AMERICA, LLC

-- Remove the Information Electronics Control Module 1 -J794- -1- from the glove compartment at the :T10057 grip eyes.

-- Release and disconnect the connectors from the Information Electronics Control Module 1 -J794- -1-.

-- Insert the :VAS6223/9 -1- onto the MOST bus connector -2-.

Fig 1: Fiber-Optic Cable Harness Connector And Protective Cap For Cable Connector VAS 6223/9

Courtesy of AUDI OF AMERICA, LLC

-- Press the release tabs on the Information Electronics Control Module 1 -J794- and remove the :T10057 .