Adding UV-Leak Detection Additive when the Refrigerant Circuit is Empty

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2022 Audi SQ5, 2022 Audi Q5 e, 2022 Audi Q5, 2021 Audi SQ5, and 2021 Audi Q5 e. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Identifying Cartridge & One Unit

Courtesy of AUDI OF AMERICA, LLC

The cartridge -A- contains 15.4 ml of UV-leak detection additive (one unit -B- corresponds to 2.5 ml).

-- Assemble the Leak Detection Kit: VAS6201A -1- with the cartridge -2- Leak Detection Kit - Cartridge: VAS6201/2 .

Fig 2: Assembling Hand Pump VAS 6201 With Cartridge - VAS 6201/2

Courtesy of AUDI OF AMERICA, LLC

-- Insert the Leak Detection Kit - Filler Tube: VAS6201/8 . Refer toAdd UV-Leak Detection Additive using the in the Refrigerant Circuit => Leak Detection Kit - Filler Tube: VAS6201/8 -item 7- into the hand pump.

-- Open the hand pump service valve.

NOTE:

UV-Leak detection additive is best added to the empty refrigerant circuit via a service connection or an opened connection.

If the refrigerant circuit is empty, then it is better to add the UV-leak detection additive via a connection point (for example, when the connection point is already open). This way no UV-leak detection additive remains in the service connection and the connection does not need to cleaned.

Add the UV-leak detection additive to the refrigerant circuit via a service connection. Refer to Adding UV-Leak Detection Additive when the Refrigerant Circuit is Full .
Add the UV-leak detection additive to the refrigerant circuit via an opened connection. Refer to Add the UV-Leak Detection Additive to the Refrigerant Circuit via an Opened Connection .