Seam Seal, Removing And Installing: Installing
WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2022 Audi SQ5, 2022 Audi Q5 e, 2022 Audi Q5, 2021 Audi SQ5, and 2021 Audi Q5 e. However, it is still accessible from the selected car via links, so may be relevant.
Install in reverse order of removal and note the following:
- The vehicle and the seal must be at room temperature.
- The adhesive surfaces must be free of dirt and grease.
- If the Bonding Agent:D 355 205A2 dries longer than 3 hours, then it must be primed again.
- So that the seam seal does not loosen or slide, do not close the door for two hours.
-- Remove the adhesive residue using :VAS6349 .
-- Clean the adhesive surface using the Cleaning Solution:D 009 401 04 .
-- Apply Bonding Agent:D 355 205A2 on the adhesive surface using the Applicator:D 009 500 25 and let dry.
-- Bring the seam seal -2- on the joint to the window guide -3- in the installation position.
-- Remove the protective film from the adhesive strip -1- and attach the lower seam seal to the door cover -4-.
-- Press the seam seal on the door flange -arrows-.
- Resting time of the vehicle is a minimum of two hours with the doors open at room temperature.