Side Spoiler, Removing And Installing: Installing
WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2022 Audi SQ5, 2022 Audi Q5 e, 2022 Audi Q5, 2021 Audi SQ5, and 2021 Audi Q5 e. However, it is still accessible from the selected car via links, so may be relevant.
Install in reverse order of removal and note the following:
-- Check the foam seal -4- for damage.
-- Clean the adhesive surface using the Cleaning Solution:D 009 401 04 .
-- Fold back the ends of the protective film, or attach a pulling aid to the protective film -3-.
-- Align the spoiler -6- with an alignment pin -2- on the rear lid -1-.
-- Remove the protective film from the pulling aids and from the adhesive tape -5-.
-- Push on the spoiler until it engages audibly on the rear lid.
-- Push the entire length of the spoiler on using the :3356 .
- Vehicle resting time is at least one hour at room temperature.
- It is durable after at least 24 hours.