Roof Railing, Removing And Installing: Installing

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2022 Audi SQ5, 2022 Audi Q5 e, 2022 Audi Q5, 2021 Audi SQ5, and 2021 Audi Q5 e. However, it is still accessible from the selected car via links, so may be relevant.

-- Clean the threaded pin threads on the roof railing with a wire brush.

-- Check the seal for damage and replace if necessary.

-- Carefully remove any remaining locking fluid from the nut threads that are installed with locking fluid using a thread tap.

TIP:

NOTE:

There is no cleaning procedure, since there is a risk of the threaded pins shearing off when disassembling again.

-- Insert the roof railing with the guide pin into the mount on the vehicle roof.

-- Install the nuts with locking fluid and tighten.

Further installation is the reverse order of removal.