Lifter, Removing And Installing: Installing
WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2022 Audi SQ5, 2022 Audi Q5 e, 2022 Audi Q5, 2021 Audi SQ5, and 2021 Audi Q5 e. However, it is still accessible from the selected car via links, so may be relevant.
-- Clean the adjusting screw threads -3- with a wire brush.
-- Clean the threaded hole of the lifter -1- of locking compound residue with a thread tap.
-- Check the stop washer -2- for damage and replace the lifter, if necessary.
- The stop washer must sit in the groove -arrow-.
-- Install the adjusting screw with locking fluid in the lifter.
-- Insert the lifter into the roof opening and secure it with the adjusting screw.
Further installation is the reverse order of removal.