Wheel Cover, Removing And Installing, Rear: Removing
WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2022 Audi SQ5, 2022 Audi Q5 e, 2022 Audi Q5, 2021 Audi SQ5, and 2021 Audi Q5 e. However, it is still accessible from the selected car via links, so may be relevant.
-- Loosen the rear wheel housing liner from the retainer in the bumper cover area. Refer to REAR WHEEL HOUSING LINER, REMOVING AND INSTALLING .
-- Release the catches -arrows- using needle nose pliers between the side panel mount -4- and the bumper cover -3-, and remove the wheel cover -2- from the bumper cover.
-- Carefully warm up the wheel cover using the :VAG1416 .
-- Pry up the wheel cover with the :T10383/1 from the side panel -1- at the same time do not damage the paint coat.