General Information - Name Badges And Emblems, Replacing

Special tools and workshop equipment required 

• Roller :3356 
• Cleaning Solution :D 009 401 04 
• Applicator :D 009 500 25 
• Bonding Agent :D 355 205A2 

• Loosened name badges and emblems must be replaced.
• The vehicle as well as the name badges and emblems must be at room temperature.
• The adhesive surfaces must be free of dirt and grease.
• If the Bonding Agent :D 355 205A2  dries longer than 3 hours, then it must be primed again.

-- Clean the adhesive surfaces using Cleaning Solution :D 009 401 04  .

-- Apply Bonding Agent :D 355 205A2  on the adhesive surface using the Applicator :D 009 500 25  and let dry.

-- Warm the adhesive areas to approximately 40 °C (104 °F) using a hot air blower.

• Neighboring components must be protected against temperature effects.

-- After successfully assembling, press on the emblems again with the roller.