Molded Foam Part, Removing And Installing: Installing

Install in reverse order of removal and note the following:

For Pressure Hoses with a Color Marking: 

Courtesy of AUDI OF AMERICA, LLC

-- Position the pressure hose -2- at the center of the color mark -4- in the recess at the specified marking -3- in the molded foam part -1-.

For Pressure Hoses without a Color Marking: 

-- Measure out and mark the center of the pressure hose.

-- Position the pressure hose evenly in both directions -arrows- in the recess in the molded foam part.

Continuation: 

-- Engage the pedestrian protection crash sensor -5- into the molded foam part.

-- Attach the connector -1- to the crash sensor until it clicks into place -arrow-.

Connector Lock on Pedestrian Protection Crash Sensor

Fig 1: Identifying Connector

Courtesy of AUDI OF AMERICA, LLC

-- Push in the connector lock -2- to secure the connector.