Bumper Cover, Removing And Installing: Removing
-- Detach the front section of the front wheel housing liner near the bumper. Refer to FRONT WHEEL HOUSING LINER, REMOVING AND INSTALLING, FRONT SECTION .
-- Place a drip tray under the separating point for the washer fluid hose.
-- Clamp off the washer fluid hose -3- with the : 3094 .
-- Push the release button -arrows- and disconnect the washer fluid hose for the headlamp washer system.
-- Seal off the hose coupling with clean plugs from the : VAS6122 .
-- Free up the washer fluid hose bracket -2-.
-- Disconnect the connectors -4 and 5-.
-- Remove the bolt -1- for the bumper side section.
-- Loosen the front wheel cover in the area of the bumper side section. Refer to WHEEL COVER, REMOVING AND INSTALLING, FRONT .
-- Remove the front noise insulation. Refer to NOISE INSULATION, REMOVING AND INSTALLING .
-- Remove the lock carrier cover. Refer to LOCK CARRIER COVER, REMOVING AND INSTALLING .
-- If equipped, free up and disconnect the antenna wires -3-.
-- Free up the wiring harness -2-.
-- Remove the bolts -1 and 4-.
-- Remove the bolts -1 and 2-.
-- Disengage the side section -3- from the front side panel -arrow A- and remove the bumper cover toward the front with the help of a second technician -B arrows-.