Turbocharger, Removing And Installing: Installing

Install in reverse order of removal and note the following:

• Replace the bolts that were tightened with an additional turn after removing them.
• Replace seals, gaskets, O-rings and self-locking nuts after disassembly.
• Coat the turbocharger stud bolts with hot bolt past. Refer to the Parts Information.
• Fill the turbocharger with engine oil at the oil supply line connection.
• Secure all hose connections with hose clamps that match the ones used in series production. Refer to the Parts Information.
• After installing the turbocharger, let the engine idle for approximately one minute without increasing the engine speed. This ensures adequate oil supply to the turbocharger.
• Used coolant cannot be used again.

-- Install the cam adjustment actuators. Refer to CAM ADJUSTMENT ACTUATOR, REMOVING AND INSTALLING .

-- Install the catalytic converter. Refer to CATALYTIC CONVERTER, REMOVING AND INSTALLING .

-- Install the exhaust system without tension. Refer to EXHAUST SYSTEM, INSTALLING WITHOUT TENSION .

-- Install the air filter housing. Refer to AIR FILTER HOUSING, REMOVING AND INSTALLING .

-- Fill the coolant. Refer to Coolant, Filling .

-- Oil Level, Checking. Refer to ENGINE OIL LEVEL, CHECKING AND CORRECTING IF NECESSARY .