Transfer Fuel Pump -G6-, Checking, TDI Vehicles: Assembling

WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2020 Audi S4, 2019 Audi S4, 2019 Audi A4 allroad, 2019 Audi A4, and 2018 Audi S4. However, it is still accessible from the selected car via links, so may be relevant.

Assemble in the reverse order of removal. Note The Following:

The ignition must be off.

NOTE:

Decrease the fuel pressure by opening the shut-off valves -B and C- and letting the fuel run into the measuring container before removing the pressure gauge -1-.

Fig 1: Identifying Shut-Off Valves A And B On Pressure Tester Kit

Courtesy of AUDI OF AMERICA, LLC

-- Remove the :VAS6551 with the connecting cables.

-- Secure the fuel supply line with a hose clamp and then pull on it to make sure the fuel supply line is secure.

-- Install the engine cover. Refer to ENGINE COVER, REMOVING AND INSTALLING (2.0L TFSI) .