Fuel Pump Control Module -J538-, Removing And Installing: Removing

WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2020 Audi S4, 2019 Audi S4, 2019 Audi A4 allroad, 2019 Audi A4, and 2018 Audi S4. However, it is still accessible from the selected car via links, so may be relevant.

-- Observe the safety precautions. Refer to SAFETY PRECAUTIONS .

-- Follow the guidelines for clean working conditions. Refer to GUIDELINES FOR CLEAN WORKING CONDITIONS .

Cabriolet:

-- Remove The Right Rear Side Trim Panel. Refer to LUGGAGE COMPARTMENT SIDE TRIM PANEL, REMOVING AND INSTALLING .

-- If installed, remove the Right Rear Subwoofer -R240-. Refer to SUBWOOFER -R211-, REMOVING AND INSTALLING / OVERVIEW - SOUND SYSTEM .

All:

-- Remove the bench seat / single seat. Refer to BENCH SEAT/SINGLE SEAT, REMOVING AND INSTALLING .

-- Release the catches -arrows- using a screwdriver and remove the Fuel Pump Control Module -J538- -1- from the bracket.

Courtesy of AUDI OF AMERICA, LLC

-- Remove the fuel pump control module from under the sill panel/side trim panel.

-- Release the connector safety catch and disconnect the connector -2- for the Fuel Pump Control Module -J538-.