Fuel Tank Pressure Sensor -G400-, Removing And Installing: Removing
WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2020 Audi S4, 2019 Audi S4, 2019 Audi A4 allroad, 2019 Audi A4, and 2018 Audi S4. However, it is still accessible from the selected car via links, so may be relevant.
-- Observe the safety instructions. Refer to SAFETY PRECAUTIONS .
-- Follow the guidelines for clean working conditions. Refer to GUIDELINES FOR CLEAN WORKING CONDITIONS .
-- Remove the right rear wheel housing liner. Refer to REAR WHEEL HOUSING LINER, REMOVING AND INSTALLING .
-- Disconnect the vent and bleeder lines -1, 2 and 3-. Disconnect the connector couplings. Refer to CONNECTOR COUPLINGS, DISCONNECTING .
-- Disengage the vent and bleeder lines from the bracket -arrow- and move to the side.
-- Disconnect the connector -4- by unlocking the connector safety catch.
-- Remove the bolts -1-.
-- Remove the fuel tank pressure sensor -2- from the EVAP canister in direction of -arrow-.