Accelerator Pedal Position Sensors -G79- / -G185-, Removing And Installing: Installing
WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2020 Audi S4, 2019 Audi S4, 2019 Audi A4 allroad, 2019 Audi A4, and 2018 Audi S4. However, it is still accessible from the selected car via links, so may be relevant.
Install in reverse order of removal and Note The Following:
-- Engage the accelerator pedal module on the bottom of the pedal bracket, insert the centering pin and tighten the bolt.
NOTE:
Depending on the engine/transmission combination, an adaptation must be performed after replacing.
If a corresponding menu item is in the engine electronics tree structure under "functions", perform the adaptation using the Vehicle Diagnostic Tester.