Transmission Fluid Pump, Removing And Installing: Removing
WARNING: This page does not describe the selected car, but rather 14 other vehicles, including the 2020 Audi A4 allroad, 2020 Audi A4 Quattro, 2020 Audi A4, 2019 Audi A5 Quattro, and 2019 Audi A4 allroad. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
General repair instructions. Refer to REPAIR INFORMATION .
Guidelines for clean working conditions. Refer to GUIDELINES FOR CLEAN WORKING CONDITIONS .
- Move vehicle onto a four-pillar workshop hoist or over a work pit so that it is absolutely horizontal for the refilling.
-- Remove the noise insulation. Refer to OVERVIEW - NOISE INSULATION / NOISE INSULATION, REMOVING AND INSTALLING .
- Rear noise insulation, A4/A5
- Center noise insulation, Q5
-- Place the :SMN372500 underneath.
WARNING:
Danger of eye injury.
- Wear protective eyewear.
CAUTION:
Risk of electrical corrosion.
- There must not be any transmission fluid (MTF) in the connector area.
- Disconnect the connector -2- only after the transmission fluid drains.
NOTE:
When removing the oil pump, the transmission drains abruptly.
-- Remove the bolts -arrows- and then remove the oil pump -1-.
-- After draining the transmission fluid, disconnect the connector -2-.
CAUTION:
Risk of damaging the transmission.
Without any or with too little transmission fluid inside the transmission:
- Do not start the engine.
- Do not tow the vehicle.