Selector Lever Handle, Removing And Installing: Installing
WARNING: This page does not describe the selected car, but rather 14 other vehicles, including the 2020 Audi A4 allroad, 2020 Audi A4 Quattro, 2020 Audi A4, 2019 Audi A5 Quattro, and 2019 Audi A4 allroad. However, it is still accessible from the selected car via links, so may be relevant.
Install in the reverse order of removal while Noting The Following:
-- Check the clips -arrows- on the bottom of the selector lever handle upper section -1- are seated correctly, and if necessary press them in farther.
-- Attach the selector lever handle upper section to the selector lever handle lower section.
-- Clip in the selector lever boot on the Selector Lever Transmission Range Display -Y5-.
-- Check the selector mechanism. Refer to GEARSHIFT MECHANISM, CHECKING .