Overview - MECHATRONIC: Notes
WARNING: This page does not describe the selected car, but rather 14 other vehicles, including the 2020 Audi A4 allroad, 2020 Audi A4 Quattro, 2020 Audi A4, 2019 Audi A5 Quattro, and 2019 Audi A4 allroad. However, it is still accessible from the selected car via links, so may be relevant.
- Transmission Fluid Pan
- Removing and installing. Refer to TRANSMISSION FLUID PAN, REMOVING AND INSTALLING .
- Bolt
- Tightening specification and sequence. Refer to Figure.
- Always replace after removing.
- M6 X 30
- Seal
- Replace after removing.
- Bolt
- Tightening specification and sequence. Refer to OVERVIEW - MECHATRONIC .
- Always replace after removing.
- Bracket
- Hydraulic Pressure Sensor 1 -G545- and Hydraulic Pressure Sensor 2 -G546-
- Removing and installing. Refer to OVERVIEW - MECHATRONIC .
- Seals
- Always replace after removing.
- Contact Element
- Bolt
- 3 Nm + 90°
- Always replace after removing.
- M6 X 25
- O-ring
- Always replace after removing.
- Bleed Pipe
- Dust Ring
- Seals
- Replace after removing.
- Seal
- Always replace after removing.
- Depending on the model
- For vehicles with Parking Lock Solenoid -N486-
- Mechatronic
- Removing and installing. Refer to MECHATRONIC, REMOVING AND INSTALLING .
- Mechatronic Bolts
- Tightening specification and sequence. Refer to OVERVIEW - MECHATRONIC
- Removing and installing. Refer to MECHATRONIC, REMOVING AND INSTALLING .
- M6 X 90
- Bolt
- 3 Nm + 90°
- Always replace after removing.
- For vehicles with Parking Lock Solenoid -N486-
- M6 X 22
- Seal
- Always replace after removing.
- Transmission Control Module -J217-
- Oil Pipe
- Depending on the model
- For vehicles with Parking Lock Solenoid -N486-
- Wiring Guide
- Always replace after removing.
- Seals
- Always replace after removing.
- ATF Pipe
- Always replace after removing.
- Seals
- Always replace after removing.