Transmission Fluid Auxiliary Hydraulic Pump -V552-, Removing And Installing: Installing

WARNING: This page does not describe the selected car, but rather 14 other vehicles, including the 2020 Audi A4 allroad, 2020 Audi A4 Quattro, 2020 Audi A4, 2019 Audi A5 Quattro, and 2019 Audi A4 allroad. However, it is still accessible from the selected car via links, so may be relevant.

CAUTION:

Contamination damages the Mechatronic.

A clean work environment is required for working on the Mechatronic.

Courtesy of AUDI OF AMERICA, LLC

Place the ATF pump on the ATF motor at the same time pay attention to the correct alignment of the anti-twist mechanism -arrows-.
Courtesy of AUDI OF AMERICA, LLC

Drive the ATF motor and ATF pump using the :T10492 in the valve body.
With the :T10492 install and tighten the bolts evenly all the way.
Remove the Locking Pin T10492 .
Install the Transmission Control Module -J217-. Refer to TRANSMISSION CONTROL MODULE -J217-, REMOVING AND INSTALLING .

After replacing the Transmission Fluid Auxiliary Hydraulic Pump -V552- the function "calibrating the fluid auxiliary hydraulic pump" must be performed. Refer to Vehicle Diagnostic Tester.