Flywheel, Removing And Installing: Installing

WARNING: This page does not describe the selected car, but rather 14 other vehicles, including the 2020 Audi A4 allroad, 2020 Audi A4 Quattro, 2020 Audi A4, 2019 Audi A5 Quattro, and 2019 Audi A4 allroad. However, it is still accessible from the selected car via links, so may be relevant.

Install in reverse order of removal. At the same time note the following:

-- Always clean the transmission housing in the area where the differential is accessed -arrow A- and the shaft seal -arrow B-.

Courtesy of AUDI OF AMERICA, LLC

NOTE:

Replace the shaft seal between the differential and transmission housing -arrow B- if it is damaged.

-- Fill the space between the sealing/dust lip halfway with sealing grease. Refer to the parts information for the correct sealing grease.

-- Clean the input shaft -arrow-.

Courtesy of AUDI OF AMERICA, LLC

-- Lubricate the input shaft splines using Grease for Clutch Disc Shaft Splines :G 000 100 .

-- Slide the clutch module onto the input shaft -arrow- carefully without tilting it.

Courtesy of AUDI OF AMERICA, LLC

-- Remove the :T40176 from the flywheel -A-.

Courtesy of AUDI OF AMERICA, LLC

-- Install the left flange shaft. Refer to LEFT FLANGE SHAFT, REMOVING AND INSTALLING .