Dual Clutch, Removing And Installing: Installing: Notes
WARNING: This page does not describe the selected car, but rather 14 other vehicles, including the 2020 Audi A4 allroad, 2020 Audi A4 Quattro, 2020 Audi A4, 2019 Audi A5 Quattro, and 2019 Audi A4 allroad. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
The double shaft seal for the input shaft must always be replaced! Refer to INPUT SHAFT SEAL, REPLACING .
-- Check if the sleeves -1 and 2- are installed.
-- Coat the new seals -3, 4 and 5- with ATF and install.
-- Insert the seal -6-.
NOTE:
Make sure no dirt can fall into the transmission while cleaning.
-- Install the engaging bearing with the slave cylinder and tighten the three bolts -arrows- evenly.
NOTE:
Depending on the version the three bolts -arrows- may not be present.
NOTE:
Pay attention that the engaging bearing is installed correctly to the slave cylinder.
The ball bearings are visible! -Arrow-
-- Install the :T40288 in the threaded hole approximately 120° offset.