Drive Back The Parking Brake Motor:
-Drive Back The Parking Brake Motor: -
-- Connect the Vehicle Diagnostic Tester to the vehicle data link connector when the ignition is switched off.
-- Switch the ignition on.
-- Select Diagnostic and start.
-- Select the Test plan tab.
-- Select Select individual tests... and select the following tree structures consecutively:
- Chassis
- Brake System
- 01 - OBD-capable systems
- 03 - ABS Control Module J104 integrated parking brake
- 03 - Electric parking brake functions
- 03 - Brake pads, removing
-- Start the selected program and follow the instructions on the Vehicle Diagnostic Tester display.
-- Free up the wire by removing the protective cap -2- from the bleeder screw and opening the clip -1-.
-- Carefully remove the contact -4- for the brake pad wear indicator sensor using pliers while paying attention to the clip -3-.
If the clips go missing, the brake pad wear indicator sensor wire must be replaced.
-- Remove the bolts -arrows- by counterholding the guide pins -1 and 2-.
-- Remove the brake caliper and guide the brake pad wear indicator sensor wire out at the same time.
Risk of damaging the brake hose, brake line and brake piston.
- Do not let the brake caliper hang on the brake hose. Do not support the weight with the brake hose.
- Replace the brake hose if damaged.
- The brake line must not be bent.
- A damaged brake line must be replaced.
- Do not press the brake pedal when the brake caliper is removed.
- Do not operate the parking brake when the rear brake caliper is removed.
- A damaged brake piston must be replaced.
-- Hang the brake caliper using a suitable wire.
-- Remove the brake pads.