Overview - Rear Brakes
- Bleeder Screw
- 10 Nm
- Before installing, thinly coat with Assembly Paste:G 052 150 A2 .
- Protective Cap
- Bolt
- 35 Nm
- Always replace after removing
- Self-locking
- When loosening and tightening, counterhold at the guide pin
- Seal
- Always replace after removing
- Bolt
- 12 Nm
- Electro-Mechanical Parking Brake Motor
- Left Parking Brake Motor -V282-
- Right Parking Brake Motor -V283-
- Removing and installing. Refer to LEFT AND RIGHT PARKING BRAKE MOTOR -V282- / -V283-, REMOVING AND INSTALLING
- Guide Pin
- Check ease of movement
- Clip
- Brake Pad Wear Indicator Sensor Wire
- With Left Rear Brake Pad Wear Sensor -G36- /Right Rear Brake Pad Wear Sensor -G37-
- For inner brake pad
- Replace when replacing the brake pads.
- Removing and installing. Refer to REAR BRAKE PAD WEAR INDICATOR SENSOR, REMOVING AND INSTALLING
- Protective Cap
- Replace if damaged
- Banjo Bolt
- 10 Nm + 45°
- Replace together with the brake hose
- Permanent with gaskets
- Check for damage
- Clean any corrosion from the sealing surface on the brake caliper
- Brake Hose
- Pay attention to the correct routing: Make sure the brake hose is not blocked, bent or rubbing against the vehicle
- Replace if damaged
- Make sure that tabs are properly seated in the grooves on the bracket.
- Rivet
- Bracket
- For the brake line/hose
- On the body
- Spring
- Replace if damaged
- Brake Line
- Brake line to brake hose tightening specification: 14 Nm
- Bolt
- 8 Nm
- Bracket
- For brake hose
- Bolt
- 100 Nm + 90°
- Always replace after removing
- Self-locking
- Wheel Bearing Housing
- Brake Shield
- Removing and installing. Refer to REAR BRAKE SHIELD, REMOVING AND INSTALLING
- Bolt
- 10 Nm
- Brake Rotor
- Do not use excessive force to separate the brake rotor from the wheel hub. Use rust remover, if necessary, otherwise the brake rotor could be damaged.
- Replace on both sides of axle if worn.
- Brake rotor wear limit. Refer to TECHNICAL DATA .
- Removing and installing. Refer to REAR BRAKE ROTOR, REMOVING AND INSTALLING
- Bolt
- 10 Nm
- Brake Pads
- Check the pad thickness. Refer to the appropriate service information.
- Removing and installing. Refer to REAR BRAKE PADS, REMOVING AND INSTALLING
- Always replace on both axles.
- Brake Carrier
- Delivered as an assembled replacement part with sufficient grease on the guide pins
- Removing and installing. Refer to REAR BRAKE CARRIER, REMOVING AND INSTALLING
- Clean the contact surfaces for the brake pads and thinly coat with Lithium Grease:G 052 150 A2
- Brake Caliper
- Removing and installing. Refer to REAR BRAKE CALIPER, REMOVING AND INSTALLING
- Replacing. Refer to REAR BRAKE CALIPER, REPLACING
- After servicing or replacing, perform "Guided Fault Finding" using the Vehicle Diagnostic Tester.