Left And Right Parking Brake Motor -V282- / -V283-, Removing And Installing: Installing

Install in reverse order of removal and Note The Following: 

• Replace the seal after removal.
• The ring groove for the gasket and the parking brake motor contact surface must not be damaged.

-- Clean the parking brake motor ring groove and contact surface.

-- Install the new seal.

TIP: 

Make sure that the gasket is not removed while assembling the parking brake motor.

-- Bring the parking brake motor -1- into the installation position while turning the parking brake motor back and forth slightly.

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Tighten the bolts -arrows-.

• The parking brake motor must be flush with the brake caliper. Under no circumstances may it be pulled against the brake caliper with bolts.

-- Perform a basic setting after installing:

-- Connect the Vehicle Diagnostic Tester to the vehicle diagnostic connection when the ignition is switched off.

-- Switch the ignition on.

-- Select Diagnostic  and start.

-- Select the Test plan  tab.

-- Select the Select individual test  button and select the following tree structure consecutively:

• Chassis
• Brake System
• 0001  - OBD-capable systems
• 0003  - ABS Control Module -J104-, integrated parking brake
• 0003  - Electronic parking brake functions
• 0003  - Basic setting

-- Start the selected program and follow the instructions on the Vehicle Diagnostic Tester display.