Rear Brake Pad Wear Indicator Sensor, Removing And Installing: Removing

-- Remove the rear wheel. Refer to WHEEL, CHANGING AND MOUNTING / WHEEL BOLT TIGHTENING SPECIFICATIONS .

-- Disconnect the connector -2- from the brake pad wear indicator sensor.

Courtesy of AUDI OF AMERICA, LLC

-- Release the connector -1- to the brake pad wear indicator sensor contact from its bracket in the direction of -arrow A- while turning it 90° at the same time in the direction of -arrow B-.

-- Free up the wire by removing the dust cap -2- from the bleeder screw and opening the clip -1-.

Courtesy of AUDI OF AMERICA, LLC

-- Carefully remove the contact -4- for the brake pad wear indicator sensor using pliers while paying attention to the clip -3-.