Overview - Pedestrian Protection
WARNING: This page is about a different car, the 2019 Audi S5 Sportback, 2019 Audi A5 Sportback, 2018 Audi S5 Sportback, and 2018 Audi A5 Sportback. However, it is still accessible from the selected car via links, so may be relevant.
- Pedestrian Protection Crash Sensor 2
- LHD in the direction of travel on the left side: Driver Side Pedestrian Protection Crash Sensor 2 -G851-
- LHD in the direction of travel on the right side: Front Passenger Side Pedestrian Protection Crash Sensor 2 -G852-
- RHD in the direction of travel on the right side: Driver Side Pedestrian Protection Crash Sensor 2 -G851-
- RHD in the direction of travel on the left side: Front Passenger Side Pedestrian Protection Crash Sensor 2 -G852-
- Unit with pressure hose
- Component location: in the molded foam part on the impact member
- Must be replaced when
- The molded foam part is visibly damaged.
- The impact member is visibly deformed.
- Bumper cover very damaged / visibly damaged
- The pressure hose is damaged.
- Place the pressure hose in the groove on the molded foam part.
- Insert the pressure hose in the center of the molded foam part, the projecting end is the same on both the left and right side.
- Do not kink or squeeze the pressure hose.
- Removing and Installing. Refer to PEDESTRIAN PROTECTION CRASH SENSOR, REMOVING AND INSTALLING .
- Pedestrian Protection Crash Sensor in Direction of Travel on the Right Side
- LHD: Front Passenger Side Pedestrian Protection Crash Sensor -G571-
- RHD: Driver Side Pedestrian Protection Crash Sensor -G570-
- Equipped on some models
- Component location: on the bumper cover bracket
- Removing and Installing. Refer to Pedestrian Protection Center Crash Sensor -G693-, REMOVING AND INSTALLING .
- Bolt
- 8 Nm
- Pedestrian Protection Center Crash Sensor -G693-
- Component location: on the bumper cover bracket
- Removing and Installing. Refer to Pedestrian Protection Center Crash Sensor -G693-, REMOVING AND INSTALLING .
- Bolt
- 8 Nm
- Pedestrian Protection Trigger in Direction of Travel on the Right Side
- LHD: Pedestrian Protection Trigger 2 -G599-
- RHD: Pedestrian Protection Trigger 1 -G598-
- Triggered Pedestrian Protection, Resetting. Refer to HINGE, RESETTING
- Removing and Installing. Refer to Pedestrian Protection Trigger 1 -G598- / Pedestrian Protection Trigger 2 -G599-, REMOVING AND INSTALLING .
- Clip
- Seal
- Seal
- Clip
- Pedestrian Protection Trigger in Direction of Travel on the Left Side
- LHD: Pedestrian Protection Trigger 1 -G598-
- RHD: Pedestrian Protection Trigger 2 -G599-
- Triggered Pedestrian Protection, Resetting. Refer to HINGE, RESETTING
- Removing and Installing. Refer to Pedestrian Protection Trigger 1 -G598- / Pedestrian Protection Trigger 2 -G599-, REMOVING AND INSTALLING .
- Bolt
- 8 Nm
- Pedestrian Protection Crash Sensor in Direction of Travel on the Left Side
- LHD: Driver Side Pedestrian Protection Crash Sensor -G570-
- RHD: Front Passenger Side Pedestrian Protection Crash Sensor -G571-
- Equipped on some models
- Component location: on the bumper cover bracket
- Removing and Installing. Refer to Pedestrian Protection Center Crash Sensor -G693-, REMOVING AND INSTALLING .