Charge Air System, Checking For Leaks

Special tools and workshop equipment required 

• Turbo System Tester Kit:VAG1687  with Turbo System Tester Kit - Adapter 6:VAG1687/6  and Adapter:VAG1687/3  , Turbo System Tester Kit - Adapter :VAG1687/13-2  , Turbo System Tester Kit - Adapter :VAG1687/15  .

Procedure 

-- Remove the engine cover. Refer to ENGINE COVER .

-- Remove the lock carrier cover. Refer to Front Bumper .

-- Remove the bolts -arrows- and the air guide -2-.

Courtesy of AUDI OF AMERICA, LLC

-- Loosen the hose clamps -arrows-.

Courtesy of AUDI OF AMERICA, LLC

-- Remove the vacuum hose -2- and air duct pipe -1-.

-- Install the :VAG1687/6  and :VAG1687/13-2  on the turbocharger.

Courtesy of AUDI OF AMERICA, LLC

Courtesy of AUDI OF AMERICA, LLC

-- Loosen the threaded connections -arrows- and slide the clamping sleeves toward the rear.

Courtesy of AUDI OF AMERICA, LLC

-- Slightly lower the front muffler -2- and secure as shown with a cable tie -1-.

-- Seal the front muffler with the :VAG1687/3  and :VAG1687/15  .

Courtesy of AUDI OF AMERICA, LLC

-- Connect the :VAG1687  with the connection -5- on the :VAG1687/6  .

Courtesy of AUDI OF AMERICA, LLC

Refer to CHARGE AIR SYSTEM, CHECKING FOR LEAKS .

Assembling

Assemble in the reverse order of removal. Note the following:

• Secure all hose connections with hose clamps that match the ones used in series production.

-- Install the lock carrier cover. Refer to Front Bumper .

-- Install the engine cover. Refer to ENGINE COVER .

Tightening Specifications 

• Refer to OVERVIEW - AIR FILTER HOUSING
• Refer to OVERVIEW - MUFFLER
• Refer to OVERVIEW - CHARGE AIR SYSTEM .