Engine, Supporting In Installation Position
WARNING: This page is about a different car, the 2019 Audi A5 Quattro and 2018 Audi A5 Quattro. However, it is still accessible from the selected car via links, so may be relevant.
Special tools and workshop equipment required
- Engine Support Bridge: 10-222A
Procedure
-- Remove the engine cover. Refer to ENGINE COVER, REMOVING AND INSTALLING .
-- Position the : 10-222A as shown on the left and right fender bolting edges.
-- Engage the : 10-222A/11 on the engine lifting eye.
-- Pretension the engine with the spindle, do not lift.
Assembling
Assemble in the reverse order of removal. Note the following:
-- Install the engine cover. Refer to ENGINE COVER, REMOVING AND INSTALLING .