LEMON Manuals: Even more car manuals for everyone
Home >> Audi >> 2019 >> Q7 Prestige >> Repair and Diagnosis >> Suspension >> Wheels & Tire System >> Wheels, Tires And Wheel Alignment (Suspension, Wheels, Steering) >> 44 Wheels, Tires And Wheel Alignment >> Axle Alignment >> Standard Vehicle Height For Axle Alignment On Vehicles With Air Suspension, Checking >> Standard Vehicle Height For Axle Alignment On Vehicles With Air Suspension, Checking, AUDI Q8 >> Dimension Overview

Dimension Overview

Suspension Distance Between the Center of the Wheel and the Lower Edge of the Fender/Wheel Housing
  Front Axle Rear Axle Tolerance between the right and left
Specified size. Refer to (1). Tolerance Specified size. Refer to (1). Tolerance
1BK, 2MA, 2MB before product improvement 473 mm ± 7 mm 484 mm ± 7 mm Less than or equal to 10 mm
1BK, 2MA from product improvement 473 mm ± 7 mm 484 mm ± 7 mm Less than or equal to 10 mm
2MB from product improvement 451 mm ± 7 mm 467 mm ± 7 mm Less than or equal to 10 mm
(1) The specified size is based on the standard vehicle height.
CAUTION:

Premature wear due to incorrect axle alignment.

- Only perform the axle alignment if the vehicle is at standard vehicle height.

scientia non olet · About LEMON Manuals