Axle Alignment Specified Values, AUDI Q7

Conditions

The settings specified apply to the curb weight position. Refer to Dimension Overview ) or the standard vehicle height of the vehicle. Refer to Dimension Overview ). To determine the curb weight position or the standard vehicle height, the dimension -a- between the center of the wheel and the lower edge of the fender/wheel housing is determined.

Courtesy of AUDI OF AMERICA, LLC
On vehicles with wheel cover -1-, measure up to the lower edge of the fender/wheel housing.
Specified values valid for all engine versions.
Production Control Number (PR number) explanation. Refer to PRODUCTION CONTROL NUMBER (PR NUMBER) EXPLANATIONS

Front Axle	Standard Suspension 1BA Coil Springs	Standard Suspension 1BK Air Suspension	Sport Suspension 2MA, 3MB Air Suspension
Camber	- 25' ± 23'	- 43' ± 23'	- 55' ± 23'
Maximum permissible difference between both sides	30'	30'	30'
Toe-in per wheel	+ 10' ± 5'	+ 10' ± 5'	+ 10' ± 5'
Total toe-in	+ 20' ± 10'	+ 20' ± 10'	+ 20' ± 10'
Toe difference angle at 20° ¹⁾	1°29' ± 30'	1°29' ± 30'	1°29' ± 30'
Outer wheel steering angle at maximum steering angle	33° 12' ± 1°30'	33° 12' ± 1°30'	33° 12' ± 1°30'
Inner wheel steering angle at maximum steering angle	39° 24' ± 1°30'	39° 24' ± 1°30'	39° 24' ± 1°30'

Rear Axle	Standard Suspension 1BA Coil Springs	Standard Suspension 1BK Air Suspension	Sport Suspension 2MA, 3MB Air Suspension
Camber	- 50' ± 25'	- 50' ± 25'	- 50' ± 25'
Maximum permissible difference between both sides	30'	30'	30'
Toe-in	+ 20' ± 10'	+ 20' ± 10'	+ 20' ± 10'
Maximum permissible deviation in direction of travel relative to vehicle longitudinal axis	10'	10'	10'

¹⁾ Angle of outer wheel is less by this amount. It can also be indicated negatively in the wheel alignment computer depending on manufacturer.

Additional Vehicle Data

This additional vehicle data only serves for a faster diagnosis in the case of accidents.