Oil Pan Upper Section - Tightening Specifications and Sequence
WARNING: This page is about a different variant/trim than selected.
- Replace the bolts that were tightened with an additional turn after removing them.
Depending on the Version, Aluminum or Steel Bolts May be Installed.
A - Aluminum Bolts:
-- Tighten the bolts in the steps shown in the sequence:
| Step | Screws | Tightening Specification/Additional Turn |
|---|---|---|
| 1. | -1 through 18- | 8 Nm |
| 2. | -1 through 13- | 45° additional turn |
| 3. | -14 through 18- | 90° additional turn |