Oil Pan Upper Section - Tightening Specifications and Sequence
WARNING: This page is about a different variant/trim than selected.
- Replace the bolts that were tightened with an additional turn after removing them.
-- Tighten the bolts in the steps shown in the sequence:
| Step | Screws | Tightening Specification/Additional Turn |
|---|---|---|
| 1. | -1 to 14- | 8 Nm |
| 2. | -1 and 2- | 180° additional turn |
| 3. | -3 to 9- | 45° additional turn |
| 4. | -10- | 180° additional turn |
| 5. | -11 to 14- | 90° additional turn |