Oil Pan Lower Section Made of plastic - Tightening Specification and Sequence
WARNING: This page is about a different variant/trim than selected.
Courtesy of AUDI OF AMERICA, LLC
- Replace the bolts that were tightened with an additional turn after removing them.
-- Tighten the bolts in the steps shown in the sequence:
| Step |
Screws |
Tightening Specification/Additional Turn |
| 1. |
-1 to 19- |
Install by hand all the way |
| 2. |
-1 to 19- |
8 Nm |
| 3. |
-1 to 19- |
90° additional turn |