Overview - Engine Oil Cooler

WARNING: This page is about a different variant/trim than selected.

Fig 1: Exploded View Of Engine Oil Cooler

Courtesy of AUDI OF AMERICA, LLC

Sub-Assembly Bracket
- There are different versions. Refer to the Parts Information for the allocation.
- Removing and installing. Refer to SUB-ASSEMBLY BRACKET, REMOVING AND INSTALLING .
Seal
- Always replace after removing.
O-Rings
- Always replace after removing.
- Coat with engine oil
Mechanical Switch Valve
- Replacing. Refer to MECHANICAL SWITCH VALVE, REMOVING AND INSTALLING .
Engine Oil Cooler
- Removing and installing. Refer to ENGINE OIL COOLER, REMOVING AND INSTALLING .
- See note. Refer to OVERVIEW - OIL PAN/OIL PUMP, VERSION 1 - If large quantities of metal shavings or abraded material are found in the engine oil while servicing the engine, the oil passages must be carefully cleaned to prevent subsequent damage. Replace the additional oil spray jet, engine oil cooler and oil filter. .
Seal
- Always replace after removing.
- Coat with coolant
Connection
Bolt
- 8 Nm + 45°
- Always replace after removing.