Pistons, Removing And Installing: Removing

• The engine is secured to the : VAS6095A  . Refer to ENGINE, SECURING TO Engine and Transmission Holder .

-- Remove the cylinder head. Refer to CYLINDER HEAD, REMOVING AND INSTALLING .

-- Remove the oil pan upper section. Refer to OIL PAN UPPER SECTION, REMOVING AND INSTALLING .

-- Label the installation position and the piston allocation to the cylinder.

-- Mark installation position and allocation of the connecting rod cylinder -item  ) OVERVIEW - PISTONS AND CONNECTING ROD - List Item: Connecting Rod.

-- Remove the connecting rod bearing cap and remove the piston and connecting rod upward.

-- Remove the circlip -2- from the piston pin eye.

Fig 1: Locating Components of Piston

Courtesy of AUDI OF AMERICA, LLC

-- Remove the piston pin -3- using the : VW222A  .

TIP: 

If difficult to move, heat the pistons to approximately 60 °C (140 °F).

-- Remove the pistons -1- from the connecting rod -4-.