Vibration Damper, Removing And Installing, Starter Generator: Notes
WARNING: This page is about a different variant/trim than selected.
Special tools and workshop equipment required
- Wrench - 21mm: T40263
- Adapter: T40314
- Counterhold: T40378 or
- Counterhold: T40379
- Vibration Damper Assembly Tool: T10531
- Vibration Damper Assembly Tool - Adapter: T10531/5
- Assembly Tool: T10531/5-/6
- The vibration damper bolt -A- connects the vibration damper -1-, the timing chain sprocket -2- and the crankshaft -3- with each other. Before removing the bolt, the chain sprocket must be secured to the crankshaft as described in the following.