Vibration Damper, Removing And Installing, Generator: Installing

Install in reverse order of removal and note the following:

• Replace the bolt with the O-ring after removing.

-- If necessary, remove the : T10531/4  -B- and : T10531/3  -A- from the : T10531/2  .

-- Attach the vibration damper in TDC. While doing so, pay attention to the tooth contour of the chain sprocket -arrow-.

-- Place the : T10531/3  -A- on the : T10531/2  .

• At the same time the hex fitting points to the vibration damper.

-- Install the : T10531/4  -B-. While doing so, move the vibration damper back and forth slightly to check if the vibration damper is seated correctly in the tooth contour.

-- Tighten the knurled nut until the vibration damper can no longer be turned.

-- Place the : T10531/1  as shown on the vibration damper and tighten hand-tight using the knurled bolt -arrows-.

• The arrow marking on the : T10531/1  must point upward.

-- Remove the : T10531/4  -A- and loosen the tensioning pin -B-.

-- Unscrew the : T10531/2  and remove it with the : T10531/3  .

-- Install a new vibration damper bolt hand-tight with an oiled O-ring -1-.

-- Remove the knurled bolts -arrows- and remove the : T10531/1  .

-- Position the : T10355A  and tighten the vibration damper bolts.

Further installation is performed in reverse order of removal, while noting the following:

• Replace the timing chain cover bolts -arrows- after removing.

-- Install the ribbed belt. Refer to RIBBED BELT, REMOVING AND INSTALLING .

There are additional procedures depending on the model. Refer to VIBRATION DAMPER, REMOVING AND INSTALLING .