Charge Air Pressure Actuator -V465-, REMOVING AND INSTALLING: Removing

-- Remove the air filter housing. Refer to AIR FILTER HOUSING, REMOVING AND INSTALLING .

-- If necessary, remove the upper reinforcement brace. Refer to OVERVIEW - LOCK CARRIER .

-- Free up the Fuel Tank Pressure Sensor 2 -G850- at the air duct pipe.

Vehicle with High-Voltage System: 

Courtesy of AUDI OF AMERICA, LLC

-- Disconnect the connector -1-.

-- Release the retainers in direction of -arrows- and move the coolant expansion tank -2- to the side.

Air Duct Pipe, Version 1: 

Courtesy of AUDI OF AMERICA, LLC

-- Remove the vacuum hose -2- (example illustration above).

-- Loosen the hose clamp -3- and remove the air duct pipe -1-.

Air Duct Pipe, Version 2: 

Courtesy of AUDI OF AMERICA, LLC

-- Remove the vacuum hose -3-.

-- Press the release buttons on both sides and remove the secondary air injection hose -4-.

-- Loosen the hose clamp -1- and remove the air duct pipe -2-.

Continuation for All Vehicles: 

All additional procedures are described. Refer to TURBOCHARGER, REMOVING AND INSTALLING .