Center Charge Air Cooler, Removing And Installing: Removing
-- Observe the guidelines for clean working conditions. Refer to GUIDELINES FOR CLEAN WORKING CONDITIONS .
-- Remove the molded foam part. Refer to MOLDED FOAM PART, REMOVING AND INSTALLING .
-- Release the left and right catches with the : T10118 in direction of -arrows- and remove the upper air ducts -1- and side air ducts -2-. (Shown with the radiator removed).
-- Disconnect the connector -2- for the High Pressure Sensor -G65-.
Risk of damaging the refrigerant lines and hoses by removing and pivoting the condenser.
- Do not stretch, bend or kink the refrigerant lines and hoses.
-- Release the left and right catches in direction of -arrows- disengage the condenser -1- from the radiator and tie up to the side.
-- Loosen the hose clamp -2- on the left and right sides and remove the air duct hose from the charge air cooler -1-.
-- Release the retainers in direction of -arrows- on the left and right sides and disengage the charge air cooler from the radiator.
-- Remove the charge air cooler downward.