Ignition Coils, Removing And Installing: Removing
WARNING: This page is about a different variant/trim than selected.
-- Remove the air filter upper section. Refer to AIR FILTER HOUSING, REMOVING AND INSTALLING .
-- Remove the cap -2-.
-- Release the retainer in direction of -arrow B- and remove the oil filler tube -1- upward from the air filter lower section.
-- Turn the oil filler tube counter-clockwise in direction of -arrow A- and remove it.
-- Close the oil filler tube with the cap.
-- Loosen the hose clamp -arrow-, remove the air duct pipe from the air filter housing and push it slightly to the side.
All additional procedures are described. Refer to IGNITION COILS WITH POWER OUTPUT STAGES, REMOVING AND INSTALLING .