SUBFRAME Mount Sensor, Removing And Installing: Removing

WARNING: This page is about a different variant/trim than selected.

Subframe Mount Sensor 1 -G748- (left):

-- Remove the air filter upper section. Refer to AIR FILTER HOUSING, REMOVING AND INSTALLING .

Subframe Mount Sensor 2 -G749- (right):

-- Remove the front noise insulation. Refer to NOISE INSULATION, REMOVING AND INSTALLING .

Continuation for Both Sides:

Fig 1: Subframe Mount Sensor Component Location

Courtesy of AUDI OF AMERICA, LLC

-- Disconnect the connector -1-.

-- Remove the bolt -2- and remove the subframe mount sensor.