Engine, Supporting In Installation Position
Special tools and workshop equipment required
- Engine Support Bridge: 10-222A
Tools, Preparing
-- If this is unsuccessful, make a 11 mm diameter hole in both : 10-222A/1 as shown.
- Dimension -a- = 30 mm
Procedure
-- Remove the air filter housing. Refer to AIR FILTER HOUSING, REMOVING AND INSTALLING .
-- Remove the left and right headlamp cover. Refer to HEADLAMP COVER, REMOVING AND INSTALLING .
-- Position the : 10-222A on the right and left longitudinal member.
-- Tighten the : 10-222A/34 on the : 10-222A/1 with the nut -2- at the same time the adapter must engage in the longitudinal member -1- as shown.
-- Engage the : 10-222A/11 on the engine lifting eye.
-- Pretension the engine with the spindle, do not lift.
Assembling
Assemble in the reverse order of removal. Note the following:
-- Install the headlamp covers. Refer to HEADLAMP COVER, REMOVING AND INSTALLING .
-- Install the air filter housing. Refer to AIR FILTER HOUSING, REMOVING AND INSTALLING .