Coolant Recirculation Pump -V50- / Thermal Management Coolant Pump -V617-, REMOVING AND INSTALLING, AUDI Q7 VEHICLE WITHOUT PARKING HEATER, AUDI Q8: Removing
WARNING: This page is about a different variant/trim than selected.
-- Remove the right front section of the wheel housing liner. Refer to FRONT WHEEL HOUSING LINER, REMOVING AND INSTALLING .
-- Remove the bolts -arrows- from the coolant pump bracket -1-.
-- Disconnect the connector -2-.
-- Loosen the hose clamps -1-, then clamp off the coolant hoses with the : 3094 and then remove them.
-- Remove the bolts -3- and remove the coolant pump.