LEMON Manuals: Even more car manuals for everyone
Home >> Audi >> 2019 >> Q7 Prestige >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 17 (Exhaust System, Emission Controls (W/Special Tools) [CYMC]) >> 26 Exhaust System, Emission Controls >> Exhaust Pipes/Mufflers >> Clamping Sleeve Installation Position >> Tightening Specification Of The Clamping Sleeve

Tightening Specification Of The Clamping Sleeve

WARNING: This page is about a different variant/trim than selected.
Fig 1: Identifying Tightening Torque And Installed Dimension Of Clamping Sleeve
GWWN26-10627Courtesy of AUDI OF AMERICA, LLC
Clamping Sleeve Tightening Specification
Clamping sleeve -A- with two individual clamps 30 Nm
Clamping sleeve -B- with continuous clamp. 30 Nm

Tighten the threaded connections evenly.

scientia non olet · About LEMON Manuals